We've been selling many kind of AAF decals, have now released a new rubber stamp. This is the slightly different design Type II from the basic design Type I.

AAF Insignia Type II, 2" x 2", Rubber Stamp
Note) This is the slightly different design Type II from the basic design Type I.
Year of Standardised: 1941
Standard: 2" x 2"
注) The basic standard is as stated above, however please note that as this is a reproduction from the original there may be slight differences from the basic standard.
Type of Stamp: Deep Carving Rubber Stamp with Handle
Main Purpose: On A-2 Lining, A-3 Cap............
One Point Advice for Stamping:
• Select a stamp ink type that can be used on fabric.
• Be careful not to get ink on any parts of the rubber surface other than the raised areas engraved in the surface. If ink has got on the surface, be sure to wipe it off with a cotton swab soaked in alcohol before stamping.
• The stamp ink should be applied repeatedly so that it adheres evenly and sufficiently to the engraved raised areas.
• Stamping should be done for about 3-5 seconds, applying pressure evenly all over the place.
• Always test stamping on a practice cloth before the actual stamping.
Note) No matter how careful you stamp, mistakes are inevitable. Accept that small mistakes are part of the experience, and if you make a big mistake, keep practicing until you succeed. Please note that we are not responsible for any dissatisfaction, failure, or damage that occurs during stamping.